Pipeline toolbox.
Quick calculations for PE pipelines: butt weld parameters, unit conversions, pipe volume, friction loss and thermal expansion. Indicative figures for early planning, not a design.
Butt weld parameters
Heating, cooling and gauge pressure settings for butt welding PE pipe. Every welder has its own cylinder area, so the gauge pressure is worked out for your machine.
To ISO 21307:2017. Gauge pressure is the interface pressure multiplied by the pipe end area, divided by the welder's cylinder area, plus drag. Weld to the approved procedure for the job. Electrofusion settings come from the fitting's barcode.
Send this to FourtrexUnit converter
Pressure and flow in the units used on site.
Pipe volume and flush time
How much water a line holds, and how long one pipe volume takes to pass.
Velocity and friction loss
Water velocity and the pressure lost to friction along a straight run of pipe.
Hazen-Williams, C = 150, for water in straight pipe. Fittings, valves and changes in elevation are not included.
Send this to FourtrexThermal expansion
How far a PE line grows and shrinks between its coolest and warmest temperature.
PE at 0.2 mm per metre per °C, for pipe that is free to move. Buried and anchored pipe moves less.
Send this to FourtrexIndicative only. These calculators give quick figures for early planning. They are not a design and do not replace an engineer's calculations, the pipe manufacturer's data or an approved weld procedure.